Pontiac w/Edel perf rpm mfg 3/15/02 & up head stud kit
Applications
Pontiac Edelbrock Heads
Installation Instructions
Automotive Racing Products Tel: (805) 339-2200
1863 Eastman Avenue
Fax: (805) 650-0742
Ventura, Ca 93003
www.arp-bolts.com
INSTALLATION METHOD FOR HEAD STUD KITS
Part Number: 190-4305 Application: Pontiac 400-455 w/ Edelbrock RPM heads
1.
Always verify the part number for your application with the part number on the side of box and the part
number on the instruction sheet. This will help ensure you have the correct installation procedure for
your specific application before installing any components.
2.
Clean and inspect all hardware prior to installation. Look for obvious defects or shipping damages, plus proper
fit, length and dimension.
3.
To ensure proper thread engagement and accurate torque readings, clean ALL threads in the block. Chase if
necessary with ARP Thread Chaser, part number 911-0005 (1/2-13).
4.
Screw studs into the block “HAND TIGHT ONLY”.
NOTE: LOCTITE MAY BE USED IF A PERMANENT MOUNTING OF THE STUDS IS PREFERRED. THE
FASTENERS, HOWEVER, MUST BE TORQUED PRIOR TO THE LOCTITE SETTING UP.
5.
Install the cylinder head(s) and check for binding or misalignment.
6.
Lubricate the stud threads, the bottom side of the washers and the nuts with ARP ULTRA-TORQUE
FASTENER ASSEMBLY LUBRICANT. Then install the washers and the nuts onto the studs and tighten them
hand tight. ARP recommends using the ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT that
is provided with each kit as opposed to motor oil. This is due to higher friction on the studs as well as
inconsistencies in the clamping force of the fasteners when motor oil or other low quality lubricants
are used.
PRELOAD (TORQUE) RECOMMENDATIONS
7.
Following the manufacturers recommended torque sequence tighten the nuts in three equal steps to 110 ft lbs
with ARP ULTRA-TORQUE FASTENER ASSEMBLY LUBRICANT.
Note: ARP Ultra-Torque Fastener Assembly Lubricant has been specifically designed to reduce tension preload scatter and
eliminate the need to cycle high performance engine fasteners before final installation. ARP Ultra-Torque far surpasses all
requirements offered by previous ARP lubricants in terms of fastener preload repeatability and performance lubricating
properties. For more information on ARP Ultra-Torque visit our website at www.arp-bolts.com or call 1 800-826-3045.
Stud Location and Torque Sequence
For Heads Manufactured After 3/15/02
(Studs are measured by overall length in inches)
7/16/13
⚠ This is an automatically generated translation and unit conversion. Always refer to the original ARP instruction sheet for exact specifications. Errors may occur. 
