Ford Modular 2V SOHC Cam Tower Stud Kit
Applications
Ford - Modular Generic - Modular
Ford Generic - Modular
Installation Instructions
Part Number: 156-1002
Application: FORD 4.6L & 5.4L 2V MODULAR V8
Cam Tower Stud - Installation
[1]
Please check the part-number(s) for your application
against the part-number(s) listed on the instruction
sheet.
[2]
Clean and inspect all hardware prior to installation.
Look for obvious defects or shipping damages, plus
proper fit, length and dimension.
[3]
To ensure proper thread engagement and accurate
torque readings, clean the threads in the cylinder
head. Chase if necessary with a Thread Chaser or
Tap.
[4]
Screw the studs into the cylinder head “HAND TIGHT
ONLY”. Note: Loctite may be used if permanent
mounting of the studs is preferred.
[5]
Install the camshaft(s) and the camshaft caps as
described in the factory service manual.
[6]
Lubricate the stud threads, nuts and the washers with
ARP ULTRA-TORQUE FASTENER ASSEMBLY
LUBRICANT. Then install the washers and the nuts
onto the studs and tighten them hand tight
[7]
Following the manufacturer’s recommended torque
sequence tighten the M6 nuts to 89 in-lbs (10.1 Nm) using
ARP ULTRA TORQUE FASTENER ASSEMBLY
LUBRICANT.
If you have any questions or need additional information
please contact us at (805) 339-2200 or by FAX at (805)
650-0742.
⚠ This is an automatically generated translation and unit conversion. Always refer to the original ARP instruction sheet for exact specifications. Errors may occur. 
